Carburadores para automóviles y camiones

¿Estos repuestos son compatibles con tu vehículo? Averígualo ahora.

Car and Truck Carburetors

A carburetor is the part of an automobile that blends air and fuel at the proper ratio to allow for internal combustion in the engine. It has valves used for careful mixing of fuel and air in different amounts, suiting a wide range of driving conditions. If properly functioning, the vehicle will consume fuel economically and have better performance.

What are the types of carburetors?

The classification of carburetors is dependent on the number of barrels used:

  • Four-Barrel: This carburetor has a total of four barrels in one body, split into primary and secondary barrels. The first barrel set is responsible for speeding and operating engine loads while the other set regulates the fuel and airflow needed for high-speed operations. Four-barrel units are common in V-8 engines.
  • Single-Stage Two-Barrel: The single-stage has two barrels and two throttles that work collaboratively. The barrels share an acceleration pump, choke, float, and power system. Single-stage two barrels are common in six- and eight-cylinder engines.
  • Two-Stage Two-Barrel: Unlike the single-stage two-barrel design, this type contains two throttle plates operating freely. These are common among four- and six-cylinder engines.
  • One-Barrel: The one-barrel has one outlet through which everything releases into the intake manifold. It is common among four- and six-cylinder vehicles.
What factors should you consider when cleaning your carburetor?

This machine is an essential part of the vehicle since it maintains the effectiveness of the engine. Therefore, cleaning it would aid in maintaining the engines operations. Below are some of the factors to consider while cleaning your carburetor:

  • General Maintenance: The carburetor ought to be kept clean at all times to ensure its smooth running. Otherwise, its ability to control internal combustion can be compromised.
  • Tools: The right tools should be used when handling the carburetor to avoid damaging any valves or tubing. Proper tools include flat-head screwdrivers, a flexible hose, and a cross-head screwdriver.
  • Jet Cleaning: Always thoroughly clean the jets and send ports to ensure good fuel and airflow. This can be done by using a compressor to forcefully expel dirt from both of the jets.
  • Disconnecting the Carburetor: When cleaning, remember to disconnect the device prior to disassembling it, enabling you to safely clean each part.
  • Reassembly: During this stage, position the device by reattaching the plunger cap onto the choke cable before proceeding with any further step. Precise reattachment is necessary for continued proper functioning.
What parts make up the carburetor?
  • The Float System: This refers to the typical carburetor operation where fuel is flowing through inlet pipes, after which it flows to the needle before going into the float bowl.
  • The Fuel Jet: This is usually a gauged opening present at the rear end of the float bowl. It is responsible for gauging the amount of fuel and air entering the engine.
  • The Venturi Pipe: The Venturi Pipe is where a vacuum is made based on the degree of air flowing through the intake point of the carburetor. Fuel passes through the main nozzle and then lands in the venture pipe, due to the low pressure, after which it flows out of the nozzle.